Non-rotating Tri-Rod cylinder TC series

Peste 14 ani de experienta in domeniu!

  • Check Mark Promptitudine, raspunsuri si solutii rapide!
  • Check Mark Livrare rapida - predare curier in aceeasi zi!
  • Check Mark Baza de date (fise tehnice) complexa


Non-rotating Tri-Rod cylinder TC series

Ordering code: TC-M-16×40-S-G

Double acting cylinder

Pressure: 1.5Mpa

Operating temperature: -20  +70°C

Speed mm/s:  30-500

Product feature:

  1. JIS standard is implemented.
  2. Two guides of special bearing steel and linear bearing or bronze bearing guide are used to prevent rotating. They can bear high torque and radial load.                                                                                *Note: Steel ball bearing: It is suitable for elevation action of cylinder or a situation requiring high precision and high bearing ability, especially for a situation requiring low fraction action process.Bronze sliding bearing: It is suitable for action that has radial load resistance. Compared with normal cylinder of same use, the horizontal impact resistance is doubled and it has stronger torsion rigidity.
  3. Drive unit and guide unit are in the same barrel that no additional accessories are needed with minimal space required. The air intake is optional and it is convenient to install.
  4. The bottom, back side and fixating plate of main body respectively have two exact orientation orifices which can provide orientation installation with high precision for the situation.
  5. Options of switch mounting with provision 4 mounting slots.
  6. Special design of main body provides multi-mount.

Installation and application:

  1. When load changes in the work, the cylinder with abundant output capacity shall be selected.
  2. Relative cylinder with high temperature resistance or corrosion resistance shall be chosen under the condition of high temperature or corrosion.
  3. Necessary protection measure shall be taken in the environment with higher humidity, much dust or water drops, oil dust and welding dregs.
  4. Dirty substances in the pipe must be cleared away before cylinder is connected with pipeline to prevent the entrance of particles into the cylinder.
  5. The medium used by cylinder shall be filtered to 40 μ m or below.
  6. The cylinder shall avoid the influence of side load in operation to maintain the normal work of cylinder and extend the service life.
  7. Anti-freezing measure shall be adopted under low temperature environment to prevent moisture freezing.
  8. If the cylinder is dismantled and stored for a long time, please conduct anti-rust treatment to the surface. Anti-dust cap shall be inserted into the inlet and outlet ports. As the precision of the manufacture and guide is high, never dismantle the fixed block or cylinder cover without permission.




cilindru antirotatie 3 tije, cilindru tc





Pentru detalii suplimentare va stam la dispozitie.


Additional information


Usual Product Codes

3D Product Sheet