Magnetic sensors for standard cylinders JSI, SI and SGC series

Description

Magnetic sensors for standard cylinders JSI, SI and SGC series

Code CS1-B

Specifications

Dimensions for CS1-B sensors

Ordering code for CS1-B sensors

Installation method for sensors for SI, JSI si SGC cylinders

Instructions:

1. Sensor shall not fall down or bear great impact when it is installed.
2. The wire of the sensor shall not move with the action of the cylinder.
3. Clamping torque shall be within the allowable scope when the sensor is installed (0.15~0.2Nm).
4. Sensor shall be installed in the middle position of the action scope.
5. Sensor wiring:
   1. The wire is unable to bear repetitive torsion and tension. Please wire an external load before switching the power on.
   2. No poor insulation in wire.
   3. Do not wire with power line, high voltage line or use one wiring pipe.
   4. Please wire the circuit correctly based on the circuit diagram.
6. Execute scheduled maintenance by the following guidelines:
   1. make sure the sensor is firmly fixed
   2. make sure the wire is intact
   3. make sure that LED indicate the movement of the cylinder correctly
7. Other indications:
   1. It is forbidden to use the sensor in the environment with explosive gas.
   2. Magnetic sensors shall not be used in the environment with external magnetism.
   3. Magnetic sensors shall not be used in the environment that is always eroded by water.
   4. Magnetic sensors shall not be used in the environment with oil moisture or chemical substances.
   5. Magnetic sensors shall not be used in the environment with periodically changing temperature.
   6. Magnetic sensors shall not be used in the environment with excessively great impact.
   7. Magnetic sensors shall not be used in the environment with sources of electrical pulse.
   8. Avoid the environment with accumulated iron powder and dense magnetic objects.